Lancia Motor Club Forum
Model Technical and Interest => Appia => Topic started by: lancianut666 on 03 May, 2014, 04:10:36 PM
-
hi
anybody changed out a series 1 wheel the white one I have is cracked all over and is an awful colour where I poured some hot water on it to get the horn push out. Will a series 2/3 fit? any tips or advice on restoring the white one.
in anticipation
Clarkey
-
scroll halfway down the page and this is how I did my augusta wheel, if you need anymore info just give me a call, j
http://www.forum.lanciamc.co.uk/index.php?topic=1259.135
-
Very interesting, how has it held up over time ?
-
fine no problems at all, did my dads on his augusta in 2005 and that's still fine too
-
I had a long chat with Arthur Keeling a few decades ago, he explained how he rebuilt a Lambda wheel with araldite, just building it up, layer by layer and sanding back as necessary. If I recall correctly the finish was black cellulose spray. Needless to say, it, being done by Arthur, was a faultless job!! I do not know which would be easier, I think James, your fibre glass resin, with a little fine filler as necessary would be the best option. As a matter of interest James, what type of paint was used for the finish?
Andy
-
all 2 pack Andy, etch prime then 2k high build then 2k direct gloss mixed in a colour of your choice
-
As ever James, fabulous, certainly the B 12's steering wheel is cracked in several places, I will no doubt be looking for another tip or two nearer the time
P