Lancia Motor Club Forum
Model Technical and Interest => Lambda => Topic started by: JohnMillham on 10 July, 2014, 10:18:03 AM
-
My new pistons have arrived and look fine. They are lighter than the ones I removed and higher compression ratio. I was surprised to find that the gudgeon pin slides in when the piston is at room temperature, as I have always had to warm the pistons up previously. I gather that is now normal practice. So I'll be off to "Vibration Free" soon.
Regards, John
-
Having never seen an original Lambda piston, how different is it ?
Certainly looks very nice ..... and modern !
-
Not sure how original it is, but this is one which came out of my car. The new ones are lighter and with a higher compression ratio.
Regards, John
-
Very nice!!
Where did you get them made?
David
-
Paul at Vere Lancia had them made for me. He's in the Netherlands, but it looks like they were made in the USA. I'm having a set made in the same "style" for my Augusta.
Regards, John
-
The USA is also a good source for Aurelia pistons. Good quality, prices and delivery.
Chris.
-
I'm having the devil's own job of fitting the "circlips", which are simply bent wire, but very strong. After spending pretty well all day yesterday, I have one piston on its rod and very sore fingers. I tried making a special tool, but it doesn't work. What's wrong with proper circlips? They even weigh less than these horrid lumps of wire!
Regards, John
-
I eventually modified the tool and it now works. No more bruised fingers and thumbs. Pistons and rods are now in the engine.
Regards, John